Canon iR C6800 Series Service Manual page 1016

Chapter 14
14.3.35 E351
Code Detail
E351
0000
14.3.36 E400
Code Detail
E400
0001
0002
0003
14.3.37 E413
Code Detail
E413
0001
0002
14-32
Cause/Particulars of detection
There is an error in the main controller PCB (sub).
At start up, there is an error in the
communication between main
controller PCB (sub) and the main
controller PCB (main).
Cause/Particulars of detection
There is a DF communication error.
There is a check sum error.
There is a reception status error.
There is a reception interrupt error.
Cause/Particulars of detection
There is an error in the DF shift motor.
The shift HP sensor is open.
The shift HP sensor is closed.
T-14-37
Turn off the main power, and replace the main
controller PCB (sub).
If the result is not good, replace the main controller
PCB (main), and turn on the main power.
T-14-38
Disconnect and connect the harness connector; then, replace
the reader controller PCB or the ADF DC controller.
Disconnect and connect the harness connector; then, replace
the reader controller PCB or the ADF DC controller.
Disconnect and connect the harness connector; then, replace
the reader controller PCB or the ADF DC controller.
T-14-39
Check the harness; then, as necessary, replace the sensor and
motor. Check the mounting of the parts around the cam.
Check the harness; then, as necessary, replace the sensor and
motor. Check the mounting of the parts around the cam.
Remarks
Remarks
Remarks
0005-5701
0004-3289
0004-3546