Canon iR C6800 Series Service Manual page 999

Code Detail Cause/Particulars of detection
0022 The temperature reaches 80 deg C, but
does not reach 110 deg C within 180 sec.
0023 The temperature reaches 110 deg C, but
doest not reach 140 deg C within 180 sec.
0024 The temperature reaches 140 deg C, but
does not reach 170 deg C within 180 sec.
0025 The temperature reaches 170 deg C, but
does not reach 200 deg C within 180 sec.
If the outside heating roller is in contact,
within 400 sec.
0026 The temperature reaches 200 deg C, but
does not reach 230 deg C within 180 sec.
If the outside heating roller is in contact,
within 400 sec.
0030 After power on, the temperature does not
reach 50 deg C within 420 sec.
0031 The temperature reaches 50 deg C, but
does not reach 80 C deg in 420 sec.
0032 The temperature reaches 80 deg C, but
does not reach 110 deg C within 420 sec.
0033 The temperature reaches 110 deg C, but
does not reach 140 deg C within 420 sec.
The temperature reaches 140 deg C, but
0034
does not reach 170 deg C within 420 sec.
Remarks
Check for an open circuit and poor contact in the main
thermistor, thermal switch, and heater; then, reset in service
mode: COPIER>FUNCTION>CLEAR>ERR.
Check for an open circuit and poor contact in the main
thermistor, thermal switch, and heater; then, reset in service
mode: COPIER>FUNCTION>CLEAR>ERR.
Check for an open circuit and poor contact in the main
thermistor, thermal switch, and heater; then, reset in service
mode: COPIER>FUNCTION>CLEAR>ERR.
Check for an open circuit and poor contact in the main
thermistor, thermal switch, and heater; then, reset in service
mode: COPIER>FUNCTION>CLEAR>ERR.
Check for an open circuit and poor contact in the main
thermistor, thermal switch, and heater; then, reset in service
mode: COPIER>FUNCTION>CLEAR>ERR.
Check for an open circuit and poor contact in the main
thermistor, thermal switch, and heater; then, reset in service
mode: COPIER>FUNCTION>CLEAR>ERR.
Check for an open circuit and poor contact in the main
thermistor, thermal switch, and heater; then, reset in service
mode: COPIER>FUNCTION>CLEAR>ERR.
Check for an open circuit and poor contact in the main
thermistor, thermal switch, and heater; then, reset in service
mode: COPIER>FUNCTION>CLEAR>ERR.
Check for an open circuit and poor contact in the main
thermistor, thermal switch, and heater; then, reset in service
mode: COPIER>FUNCTION>CLEAR>ERR.
Check for an open circuit and poor contact in the main
thermistor, thermal switch, and heater; then, reset in service
mode: COPIER>FUNCTION>CLEAR>ERR.
Chapter 14
14-15