Canon iR C6800 Series Service Manual page 1005

14.3.10 E009
Code Detail
E009
00FF
14.3.11 E012
Code Detail
E012 There is an error in the drum/ITB motor.
0001 After motor start up, a lock state is not
identified for 1 sec or more.
14.3.12 E013
Code Detail
E013 There is clogging by waste toner.
0001 There is a waste toner full error.
The waste toner inside the toner box
(result of software conversion) is
90% or more of the capacity of the
toner box (7100 cc), i.e., the soft
counter reading is 250000 or higher.
0002 There is a waste toner feedscrew
error.
The output of the waste toner lock
detecting switch (SW14) is '1'for
more than 1 sec.
Cause/Particulars of detection
There is an outside heating roller shift error.
The outside heating roller shift motor (M22) is faulty. The outside heating roller HP sensor (PS21)
is faulty. The DC controller PCB is faulty.
The outside heating roller remains in
contact with the fixing roller.
Cause/Particulars of detection
Cause/Particulars of detection
T-14-12
Check the outside heating roller shift motor and the
fixing motor; then, turn off and then on the main power.
T-14-13
Check the area around the photosensitive drum and the intermediate
transfer belt; then, turn off and then on the main power.
T-14-14
Check the amount of waste toner; thereafter, turn the main power off
and then back on.
If you have replaced (cleaned) the waste toner box, be sure to reset
the counter using the following service mode item:
COPIER>COUNTER>MISC>WST TNR; thereafter, turn the main
power off and then back on.
Check the developing motor and the amount of waste toner;
thereafter, turn the main power off and then back on.
If you have replaced (cleaned) the waste toner box, reset the counter
using the following service mode:
COPIER>COUNTER>MISC>WST TNR; thereafter, clean the
waste toner feed pipe and turn the main power off and then back on.
Remarks
Remarks
Remarks
Chapter 14
0004-3553
0004-3071
0004-3077
14-21