Canon iR C6800 Series Service Manual page 1259

<PCHINT 2>
Attention
Settings
<PCHINT V>
Attention
Settings
<POT OFTM>
Note
settings
T-15-374
Use it to adjust the intervals of patch detection (No. 2 limit).
Use it to change the patch ATR intervals for the No. 2 limit.
For the triggers used to initiate patch detection, see the list for
PCHINT 1.
The new setting will not be valid until the power switch has been
turned off and then on.
10 to +10
at time of shipment/upon RAM initialization: 0
T-15-375
Use it to adjust the intervals of patch detection (video counter
cumulative count).
Use it to change the intervals of patch ATR in relation to the video
counter cumulative count.
The new setting will not be valid until the power switch is turned off
and then on.
10 to +10
at time of shipment/upon RAM initialization: 0
T-15-376
Use it to adjust the length of time for the detection of a disconnected
connector or to adjust the potential sensor offset.
By default, the machine executes idle rotation of the fixing roller for
1 seconce every 30 min to prevent deformation of the roller while in
standby.
The new setting will not be valid until the power switch has been
turned off and then on.
5 to 50 (unit: sec)
at time of shipment/upon RAM initialization: 5
Chapter 15
0005-6844
0005-6847
0005-6851
15-195