When Replacing The Hv2 Pcb - Canon iR C6800 Series Service Manual

software, and then perform extra steps:
1) Format the HDD.
Start up in safe mode (i.e., by turning on the main
power while holding down the 2 and 8 keys).
Using the SST's hard disk formatting function, format
all partitions. (For instructions, see the chapter on
upgrading.)
2) Download the system software.
Using the SST, download the system, language, and
RUI files. (It may take about 5 min for the machine to
start up after a download session.)
3) Start service mode.
Make the following selections in service mode:
COPIER>FUNCTION>INSTALL>CARD.
4) Enter the appropriate card No.
Enter the lowest of the numbers of the cards used for
group control, and press the OK key (e.g., enter '1' if
cards run from No. 1 to No. 1000).
5) Turn off and then on the main power.
6) Check the count control function.
In sure mode, make the following selections, and
check to see IDs between ID00000001 and
ID00001000 have been created.
7) Set the address.
Set 'IP address', 'gateway address', and 'sub net mask'
in sure mode: system control setup>network
setup>TCP/IP setup>IP address.
8) Enter the appropriate number in sure mode: system
administrator info setup>system control group
ID>system control ID No.
9) Turn off and then on the main power.
If you fail to set 'system control group ID' and
'system control ID No.', you will not be able to set
'register card to device' as part of the NetSpot
Account setup work.
10) Download the card ID.
While the machine is in a standby state, download the
card ID from NSA.
11) Check the count control function.
In sure mode, make the following selections, and
check to see that only the ID data is indicated on the
screen: system control setup>group ID control>count
control.
12) Check to see that the machine operates normally.
Make copies using a sure card that has been registered
using NSA; then, check to make sure that the use of
the card is properly indicated.
12.7.7 When Replacing the
HV2 PCB
1) Enter the settings indicated on the PCB label [1]
attached to the new HV2 for the following 6 service
mode items:
COPIER>ADJUSUT>HV TR>1TR GAIN
COPIER>ADJUSUT>HV TR>1TR OFST
COPIER>ADJUSUT>HV TR>1TR CGAI
COPIER>ADJUSUT>HV TR>1TR COFS
COPIER>ADJUSUT>HV TR>1TR GAI2
COPIER>ADJUSUT>HV TR>1TR OFS2
1TR-GAIN XXX
1TR-OFST XXX
1TR-CGAI XXX
1TR-COFS XXX
1TR-GAI2 XXX
1TR-OFS2 XXX
F-12-95
2) Generate a P PRINT printout in service mode.
3) Put the generated P PRINT printout [1] in the
service book case, replacing any existing printout.
[1]
F-12-96
Chapter 12
0004-2092
12-45