Canon iR C6800 Series Service Manual page 993

Cause
# 706
The Address Book is being imported or exported
from the Remote UI, or it is being used by another
sending component.
# 711
The inbox memory is full.
# 712
The maximum number of documents is already
stored in the inbox.
# 751
The server is not functioning. The network is down
(the server is unable to connect to the network or
was disconnected).
# 752
The SMTP server name for e mail or I fax is not
correct, or the server is not functioning.
The domain name or e mail address may not be
set. The network is down.
# 753
A TCP/IP error occurred while sending an e mail
message. (Socket, Select error, etc.)
# 754
The server is not functioning or the network is
down.
The destination setting is not correct.
# 755
You cannot send jobs because TCP/IP is not
functioning correctly.
The IP address is not set.
When the machine was turned ON, an IP address
was not assigned to the machine by the DHCP,
RARP, or BOOTP server.
# 756
NetWare in NetWare Settings in Network Settings
in System Settings (from the Additional Functions
screen) is set to 'Off'.
Wait until the Address Book import/export function from the Remote UI
or the other sending component is complete, and try sending again.
Erase the unnecessary documents stored in the inbox.
Erase the unnecessary documents stored in the inbox.
Check the recipient's address.
Check that the network is up.
Check the SMTP Server name and E mail Address in E mail/I Fax in
Network Settings in System Settings (from the Additional Functions
screen).
Check that the SMTP server is operating properly.
Check the network status.
Check the network cables and connectors. If the machine still does not
operate normally, turn the main power OFF, and then back ON again.
Check the server and network.
Check the destination's address settings.
Check TCP/IP Settings in Network Settings in System Settings (from the
Additional Functions screen).
Check TCP/IP Settings in Network Settings in System Settings (from the
Additional Functions screen).
Check TCP/IP Settings in Network Settings in System Settings (from the
Additional Functions screen).
Turn NetWare to 'On'.
Remedy
Chapter 14
14-9