Canon iR C6800 Series Service Manual page 846

Chapter 12
14) Attach the developing assembly lid you removed
in step 2), making sure that the lid is oriented as
shown.
F-12-45
Engage the 4 hooks [1], and attach the developing
assembly lid [3] using the 2 screws [2] you removed
in step 2).
[2]
[3]
[1]
F-12-46
Be sure to force the lid against the developing
container so that no transparency will enter the gap [1]
shown in the figure.
[1]
F-12-47
12-28
When tightening the screw, take care so that the
shavings from the developing unit or its lid will not
enter the unit.
15) Mount the color developing unit using the steps
you used to remove it but in reverse.
16) Turn on the main power switch.
17) Make the following selections in service mode;
then, enter '1', and
COPIER>FUNCTION>INSTALL>AINR OFF.
18) Select the appropriate mode item from the
following to suit the color of the starter you have used;
then, press the OK key
if Y developing
COPIER>FUNCTION>INSTALL>INISET Y.
if M developing
COPIER>FUNCTION>INSTALL>INISET M.
if C developing
COPIER>FUNCTION>INSTALL>INISET C.
A countdown is shown on the screen while this
mode item is under way. At the end, the screen will
show "OK!".
This mode uses ATVC control, possibly taking a
while depending on the site environment. The count
on the screen, for this reason, may loop between 690
and 620.
19) Execute the following in service mode:
COPIER>FUNCTION>MISC P>P PRINT.
put the generated printout in the service book case. If
there is any previous printout, dispose of it.
20) End service mode, and select 'auto gradation
correction' in sure mode; execute auto gradation
correction (full correction) by going through the
instructions on the screen.
press the OK key:
assembly,
assembly,
assembly,
Then,