Canon iR C6800 Series Service Manual page 845

4) Turn back over the developing unit, and turn the
developing gear in the direction in which the cylinder
normally turns so that the agent will drop into the
developing assembly.
F-12-41
5) Dispose of the agent into a vinyl bag or on paper by
turning over the developing unit.
6) Repeat steps 4) and 5) about 3 times (e.g., until no
agent drops into the developing assembly).
7) Shake the container of the starter about 10 times.
8) Detach the funnel [2] of the starter bottle [1]; then,
detach the middle lid [3], and put the funnel back on
[2].
[2] [1]
F-12-42
[3]
9) Pour the starter along the length of the stirring
screw inside the color developing unit so that it is
about half full.
F-12-43
10) Turn the developing gear in its normal direction 5
to 6 by hand to even out the starter inside it.
11) Pour the rest of the starter around the string screw
inside the color developing unit.
12) Turn the developing gear 5 to 6 times once again
to even out the starter inside the unit.
13) Move the starter that may remain on the inner side
of the unit wall [1] into the developing assembly.
F-12-44
Chapter 12
[1]
12-27