Stringing The Grid - Canon iR C6800 Series Service Manual

Chapter 7
6) Hook the charging wire [2] on the charging wire
positioner [1] at the rear; then, hook the charging wire
on the hook [3] for tension.
[1]
[2]
F-7-1161
7) Cut the excess charging wire with nippers.
8) Pick the end [1] of the tension spring with tweezers,
and hook it on the charging power supply terminal [2].
In the case of the pre transfer charging assembly,
hook the spring on the pin at the front.
F-7-1162
Make sure of the following:
the charging wire must not be bent or twisted.
the charging wire must be in the V groove of the
charging wire positioner.
(correct)
(wrong)
Grid side
(correct)
F-7-1163
9) Fit the cushion at the front of the charging wire.
(This does not apply to the primary charging
assembly.)
7-294
[3]
[1]
[2]
(wrong)
10) Mount the left and right shield plates (or, 2 lids)..
11) Mount the wire cleaner. At this time, be sure to
pay attention to the orientation of the wire cleaner.
12) Wipe the charging wire with lint free paper
moistened with alcohol.

7.11.43.4 Stringing the Grid

1) Loosen the 2 mounting screws [1] used to hold the
left and right shield plates in place.
2) Loosen the 3 mounting screws [2] used to hold the
motor unit at the front.
[1]
[2]
[1]
F-7-1164
3) Loosen the screw [1], and move the block [2] in the
direction of the arrow; then, fix it in place temporarily.
[1]
[2]
F-7-1165
4) Free a length of about 5 cm form a 0.1 mm dia
charging wire reel, and form a loop of about 2 mm in
diameter at its end.
Reference: To form a loop, wind the charging wire
around a hex key once, turn the key 3 to 4 times, and
twist the charging wire
0002-5849