E584; E590 - Canon iR C6800 Series Service Manual

14.3.51 E584

Code Detail
E584 shutter unit error (Finisher R1/R2)
8001
The shutter open sensor does not go
off (i.e., the shutter is not closed).
0002 The shutter open/closed sensor does
not go on (i.e., the shutter does not
open).
0003 hazardous area

14.3.52 E590

Code Detail
E590
8001
8002
Cause/Particulars of detection
Cause/Particulars of detection
There is an error in the punch motor. (punch unit)
The punching home position sensor is
not detected when the punch motor
has been driven for 200 msec.
The puncher does not detect the
punching home position after the
motor has stopped (initial operation).
T-14-53
1) Check the shutter home position sensor. Is the sensor normal?
2) Check the wiring between the finisher controller PCB and the stack
edging motor and between the finisher controller PCB and the shutter
open/close clutch. Is the wiring normal?
3) Is there a fault in the shutter mechanism?
4) Try replacing the stack edging motor or the shutter open/close
clutch. Is the problem corrected?
1) Check the shutter home position sensor. Is the sensor normal?
2) Check the wiring between the finisher controller PCB and the stack
edging motor and between the finisher controller PCB and the shutter
open/close clutch. Is the wiring normal?
3) Is there a fault in the shutter mechanism?
4) Try replacing the stack edging motor or the shutter open/close
clutch. Is the problem corrected?
1) Check the shutter home position sensor. Is the sensor normal?
2) Check the wiring between the finisher controller PCB and the stack
edging motor and between the finisher controller PCB and the shutter
open/close clutch. Is the wiring normal?
3) Is there a fault in the shutter mechanism?
4) Try replacing the stack edging motor or the shutter open/close
clutch. Is the problem corrected?
T-14-54
Check the punch home position sensor, horizontal
registration motor, and punch driver PCB; then, turn off and
then on the main power.
Check the punch home position sensor, horizontal
registration motor, and punch driver PCB; then, turn off and
then on the main power.
Remarks
Remarks
Chapter 14
0005-5822
0005-5823
14-39