Canon iR C6800 Series Service Manual page 1338

Chapter 16
If you choose "Register All" using version 2.01 of the SST,
ALL will not be indicated under "Batch object files registration status" and all the check boxes of the field remain
blank. Although this seems to indicate that no system software has been registered, the system software you have
selected has been registered.
(In the case of version 2.02 or later of the SST, the appropriate check boxes will be checked.)
<Making Sure That the Appropriate System Software Has Been Registered>
1) On the Models and Units screen, select 'ALL' or 'ALL_HDF'.
2) Click [Batch Download].
3) Check to see that the Batch Download File List screen indicates the paths to the individual pieces of system
software.
Service Support Tool Ver. 2.01E (DLM0) Batch Download Control Screen
Batch download list
"iR XXXX Ver2.01"
"Common to C-Boot and N-Boot"
Job
Wait "Turn off the copier, then turn on...
Download iR XXXX_SYSTEM_USen2101
Download iR XXXX_Language_XXja2101
Download iR XXXX_Language_XXen2101
Download iR XXXX_DCON_XXxx2007
Wait "Turn off the copier, then turn on...
Download iR XXXX_RUI_XXja1011
Interface
Network
Device IP:
172.16.1.100
To Unit Selection
Screen
F-16-40
Memo:
Any piece of system software that has not been registered is indicated by an appropriate notation for its path. Be sure
to use [Registering Firmware] for the work.
16-32
Path
C:\ServTool\iR XXXX\SYSTEM\USenv21.01\iR
C:\ServTool\iR XXXX\Langugage\XXjav21.01\iR
C:\ServTool\iR XXXX\Langugage\XXenv21.01\i
C:\ServTool\iiR XXXX\DCON\XXjav21.01\iR XX
C:\ServTool\iR XXXX\RUI\XXjav1011\iR XXXX
Confirm firmware versions
Same Ver:Skip/Ver down:Confirm
Confirm Overwrite
Start Batch Download