Canon iR C6800 Series Service Manual page 376

Chapter 7
7.11.9.6 Points to Note When
Mounting the DC Controller
Box
During assembly work, be sure to connect the
harness to the DC controller PCB as follows:
Connect the connector of the harness [1] first, and
then the other harness [2].
Fix the harnesses [1] [2] in place using the wire
saddle [3] so that the harness [1] is on the left side of
the harness [2].
[3]
[3]
[4]
[3]
[1]
[3]
[2]
F-7-260
Supplementary Information:
If the harness [1] is away from the side plate [4] of the
DC controller box, wrong detection (E070 0102) of
the ITB home position tends to occur because of
noise.
7-110
7.11.9.7 Removing the Drum
Motor
0005-7221
1) Remove the 2 screws [1], and detach the fly wheel
[2].
F-7-261
2) Disconnect the 2 connectors [1], and remove the 3
screws [2]; then, detach the drum motor [3].
F-7-262
1]
2]
[1] [3]
[2]
0004-1056