Canon iR C6800 Series Service Manual page 988

Chapter 14
14.2 Error Codes (SEND)
14.2.1 Self Diagnostic Display
Scanning has stopped because the size of the data for the scanned original exceeds the limit. Scanning may be
possible if [Data Cmprssn] is set to [High Ratio], Resolution is lowered, or [Sharpness] is reduced.
Scanning was stopped because the data size of the
scanned original exceeded the maximum data size that
the machine could handle.
Out of resources. Wait for a moment, then perform operation again.
You cannot browse the network. There is a lack of
TCP/IP resources because documents have just been
continuously sent or are being continuously sent
through FTP or Windows (SMB).
Set the IP Address.
This machine is not set with an IP address.
No response from the server. Check the settings.
The specified server settings are incorrect, or the
server is not turned ON. Alternatively, the machine's
TCP/IP resources may be low.
NetWare is in use. Wait for a moment, then perform operation again.
You cannot browse the network because NetWare is
printing through a Pserver or NDS PServer.
There are too many subdirectories.
You have exceeded the maximum number of
subdirectory levels allowed.
No response.
The server was not running when you tried to send.
The network connection was lost when you tried to
send. (Either you could not connect to the destination,
or the connection was lost before the job could be
completed.)
14-4
Cause
T-14-2
By selecting [High Ratio] for Data Compression
Ratio, lowering the Resolution, and lowering the
Sharpness setting, scanning may become possible.
Wait for a while, and try browsing again.
Specify the IP Address Settings in TCP/IP Settings in
Network Settings in System Settings (from the
Additional Functions screen), then turn the machine's
main power OFF and back ON again.
Wait for a while, and try browsing again. If there is
still no response from the server, try selecting another
server.
Wait until printing is complete, then try browsing
again.
Specify a different destination because the directory
level that you are trying to access cannot be specified.
Make sure that the server is ON, and check the
destination.
Check the status of the network.
Remedy
0005-6121