Sflow Polling-Interval (Global) - Dell Z9500 Reference Manual

sflow polling-interval (Global)

Set the sFlow polling interval at a global level.
Z9500
Syntax
sflow polling-interval interval value
To return to the default, use the no sflow polling-interval interval
command.
Parameters
interval value
Defaults 20 seconds
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.2.1.0
8.1.1.0
7.7.1.0
7.6.1.0
7.4.1.0
Usage The polling interval for an interface is the maximum number of seconds between
Information successive samples of counters sent to the collector. This command changes the
global default counter polling (20 seconds) interval. You can configure an interface
to use a different polling interval.
Related sflow polling-interval (Interface)
Commands
1650
Enter the interval value in seconds. The range is from 15 to
86400 seconds. The default is 20 seconds.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on S-Series Stacking.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— sets the polling interval for an interface.
sFlow