[Cm35] Trunk Route Data - NEC Univerge NEAX 2000 IPS Command Manual

COMMAND CODE TITLE:
35
FUNCTION:
This command is used to assign trunk route characteristics. A trunk route is a group of trunks with com-
mon characteristics used for a common purpose.
PRECAUTION:
(1) The table below shows the value of the Central Office trunk or Tie line trunk (COT/DID/ODT/
LDT/DTI/BRT/PRT/CCT) PAD assigned by CM35 Y=19, Data 4-7.
(T: Transmitter PAD [dB], R: Receiver PAD [dB])
[Australia/New Zealand]
CONNECTION PATTERNS
(A-B)
Station-ODT
Tone-ODT
COT/DID/LDT/IPT-ODT
ODT-ODT
DTI/BRT/PRT/CCT/Virtual IPT-ODT
Station-COT/DID/LDT
Tone-COT/DID/LDT
COT/DID/LDT/IPT-COT/DID/LDT
ODT-COT/DID/LDT
DTI/BRT/PRT/CCT/Virtual IPT-COT/DID/
LDT
Station-DTI/BRT/PRT/CCT
Tone-DTI/BRT/PRT/CCT
COT/DID/LDT/IPT-DTI/BRT/PRT/CCT
ODT-DTI/BRT/PRT/CCT
DTI/BRT/PRT/CCT/Virtual IPT-DTI/BRT/
PRT/CCT
T/R: Transmit/Receive
+ : Gain
– : Loss
TRUNK ROUTE DATA
DATA=4 (T/R)
PAD DATA OF B TRUNK
DATA=5 (T/R)
0/0
0/0
0/0
0/0
0/0
0/+6
0/+6
0/+6
0/+6
0/+6
– 342 –
DATA=6 (T/R) DATA=7 (T/R)
0/0
0/0 0/0
–8/–8 –8/–8
–8/–8 –3/–3
–8/–8 –3/–3
0/+6 0/+6
0/+6 0/+6
–6/+6 –6/+6
–6/+6 0/+6
–6/+6 0/+6
0/0
0/0
0/0
0/0
Continued on next page
NWA-008844-001 Rev.5.0
CM35
0/0
0/0
91ch3003.fm