[Cm35] Trunk Route Data - NEC UNIVERGE SV8300 Command Manual

COMMAND CODE TITLE:
35
FUNCTION:
This command is used to assign trunk route characteristics. A trunk route is a group of trunks with com-
mon characteristics used for a common purpose.
PRECAUTION:
(1) When assigning a Tie line, the data in CM35 Y=009 (Incoming connection signaling) should be
similar to that of CM35 Y=020 (Sender starting condition).
The table below shows the assignment of the sender starting condition in relation to the incoming
connection signaling.
INCOMING CONNECTION
SIGNALING (CM35 Y=009)
Ground Start (01)
Loop Start (15)
Wink Start (03)
Delay Dial (04)
Immediate (05)
2nd DT/Timing (06)
NOTE:
( ) indicates the data to be assigned.
(2) After setting CM35 Y=090, 091, system reset is required.
After setting CM35 Y=079, 133, 144, 283, blade reset is required.
TRUNK ROUTE DATA
Ground Start (02)
Loop Start (15)
Wink Start (00)
Delay Dial (01)
Timing Start (15)
Timing Start (15)
SENDER START CONDITION
(CM35 Y=020)
3-222
CM35
REMARKS
NWA-033623-001 Rev.3.0
91ch3003.fm
NOVEMBER/12/2008