Numbering Plan Assignment; Programming For Closed Numbering Plan; Table 3-3 Numbering Plan Assignments; Table 3-4 Closed Numbering Plan Assignments - NEC Univerge SV9100 Manual

1.3
Program/
Item No.
11-01-01
11-02-01
11-04-01
1.4
Program/
Item No.
11-01-01
44-02-01
44-02-02
3-4

Numbering Plan Assignment

Use these programming assignments to indicate to the system the number of
digits that are assigned to stations, the number of digits assigned to Access
Codes, and to assign stations to ports.

Table 3-3 Numbering Plan Assignments

Description/
Selection
System Numbering
Extension Numbering
Virtual Extension
Numbering

Programming for Closed Numbering Plan

Use these programs to assign an Access Code to the Intercom Function
Numbers, to assign F-Routes to the appropriate Trunk Routes, and specify the
digits that are added to the dialed number.

Table 3-4 Closed Numbering Plan Assignments

Description/
Selection
System Numbering
Dial Analysis Table for
ARS/F-Route Access –
Dial
Number of digits to be
analyzed by the system.
Dial Analysis Table for
ARS/F-Route Access –
Service Type
Assigned Data
0 = Not Used1 = Service
Code
2 = Extension Number
3 = Trunk Access
4 = Special Trunk Access
5 = Operator Access
6 = Flexible Routing
9 = Dial Extension Analyze
Assign Station Numbers to
Port Numbers
Assign Station Numbers to
Port Number
Assigned Data
2 = Extension Number
Up to eight digits can be
assigned.
Default is No Setting.
2 = ARS/F-Route Table
Default is 0
System Data Programming <US Only>
Issue 2.0
Comments
Default for 1X, 2X, and 3X is 2.
Defaults for Ports 1 ~ 960:
101 ~ 199
3101 ~ 3961
Defaults for Ports
1 ~ 99 = 201~ 299
100 ~ 512 = Not Assigned
Comments
Default for 1X, 2X, and 3X is 2.
Assign the digits to be dialed
across the K-CCIS link. These
digits were assigned as F-Route
in Program 11-01-01.
(Use line key l for "Don't Care"
digit @.)
Service type 2 assigns the digits
to be dialed to an F-Route.
Program 44-02-03 assigns the
F-Route to be used.