[Cm20] Numbering Plan/Single Digit Feature Access Code (Programmable) - NEC UNIVERGE SV8300 Command Manual

COMMAND CODE TITLE:
20
FUNCTION:
Trunk routes and features are assigned by developing access codes. For Route Advance and Tenant
development, see CM22 and CM23.
The following figure shows the relationship between commands:
Numbering Plan Group
For each
tenant
CM29 CM20
(4 groups)
PRECAUTION:
(1) If "7XX" (XX=20-83) is displayed when reading out the assigned data for the access code, the
access code which was entered is the leading digits of another access code consisting of more
digits. Add a digit to the entered access code and try again (to determine the other access code).
Then decide which one to use or delete/change (not enough digits entered).
(2) If "WRONG" is displayed when reading out the assigned data for the access code, another access
code already exists with the same leading digits. Delete the last digit and try again (to determine
the other access code). Then decide which one to use or delete/change (too many digits entered).
NUMBERING PLAN/SINGLE DIGIT FEATURE ACCESS CODE
(PROGRAMMABLE)
For each access code
Station No.
Access Code for Service Feature
Trunk Route
CM23
(24 blocks)
Numbering Plan
Tenant Block
For each Tenant
Access Code for Service Feature
Trunk Route
Special Terminal Block
Trunk Route
CM25
For each ordinary Station
(16 blocks)
3-180
CM20
Route Advance Block
Trunk
Route
CM22
Route
Advance
(32
Block
blocks)
Continued on next page
NWA-033623-001 Rev.3.0
91ch3003.fm