Acx1000 And Acx1100 Routers Quick Start Description - Juniper ACX1000 Quick Start Manual

ACX1000 and ACX1100 Routers Quick Start
Description
This Quick Start contains information you need to install and configure the router quickly. For complete
installation instructions, see the
https:/ /www.juniper.net/documentation/.
WARNING: This Quick Start contains a summary of safety warnings in
Warnings" on page
translations, see the
at https:/
The ACX Universal Metro Router is principally designed for high-density access and pre-aggregation and
is environmentally hardened. The router can be used as a cell site router or pre-aggregation device for
mobile backhaul and a CPE for business or residential access.
The routers are single-board routers with a built-in Routing Engine and one Packet Forwarding Engine.
The Packet Forwarding Engine has one "pseudo" Flexible PIC Concentrator (FPC 0). Because there is no
switching fabric, the single Packet Forwarding Engine takes care of packet forwarding.
The ACX Series router is powered by Junos OS, supporting extensive L2 and L3 features, IP/MPLS with
traffic engineering, rich network management, fault management, service monitoring and Operation,
Administration, and Maintenance (OAM) capabilities, and an open software development kit (SDK)
system that allows providers to customize and integrate operations with their own management
systems. For a list of related Junos OS documentation, see
software/junos/.
As part of the mobile backhaul, the ACX Series router at the cell site and the MX Series router at the
aggregation layer provide comprehensive end-to-end Ethernet, MPLS, and OAM features with the one
Junos OS running on both platforms.
The compact routers are one rack unit (U; that is, 1.75 in., or 4.45 cm) tall. Several routers can be
stacked in a single floor-to-ceiling rack for increased port density per unit of floor space.
The ACX1000 and ACX1100 routers contain twelve Gigabit Ethernet ports, eight of which are RJ-45
ports. The ports labeled COMBO PORTS provide an additional four RJ-45 ports or four Gigabit Ethernet
SFP ports. You can only use one set of combination ports at a time.
The ACX1000 router also contains eight T1/E1 ports.
Figure 1 on page 2 shows the front panel of the ACX1000 router.
on page 3 show the front panel of the ACX1100 router.
ACX1000 and ACX1100 Universal Access Routers Hardware Guide
20. For a complete list of warnings for this router, including
ACX1000 and ACX1100 Universal Access Routers Hardware Guide
/www.juniper.net/documentation/.
https:/ /www.juniper.net/documentation/
Figure 2 on page 2
at
"Safety
and Figure 3
1