Alias - Siemens SCALANCE XM-400 Configuration Manual

Configuration
3.1 System
Further notes
You show the created users with the
You can also change the passwords with the
3.1.13 Commands in the interface configuration mode
This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the
Global configuration mode.
● If you exit the Interface configuration mode with the
Privileged EXEC mode.
3.1.13.1

alias

Description
With this command, you assign a name to an interface. The name only provides information
and has no effect on the configuration.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
alias <interface-name>
The parameter has the following meaning:
Parameter
interface-name
Result
The interface was assigned a name.
86
show user-accounts
user-account
interface
Description
Name of the interface
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
command.
command.
command to change to this mode.
command, you return to the
exit
command, you return to the
end
Range of values / note
max. 63 characters
Configuration Manual, 11/2015, C79000-G8976-C252-10