No Monitor Session Source - Siemens SCALANCE XM-400 Configuration Manual

Diagnostics
12.4 Port Mirroring
If you do not select any parameters from the parameter list, the default value (both) is used.
Note
VLAN and ACL mirroring
Tx mirroring is not supported with VLAN or ACL mirroring.
Result
As soon as you have configured the settings for the port to be monitored and the destination
port, the session is complete and active.
Further notes
You delete the source for mirroring a port with the
You end and delete a session with the
You display the configuration settings with the
12.4.2.8

no monitor session source

Description
With this command, you delete the source for mirroring a port or a VLAN.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
804
no monitor session ... source
command.
no monitor session
show monitor session
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
command.
command.