No Syslogserver - Siemens SCALANCE XM-400 Configuration Manual

Syntax
Call up the command with the following parameters:
syslogserver { ipv4 <ucast_addr> | fqdn-name <FQDN> | ipv6 <ip6_addr>} [<port(1-
65535)>]
The parameters have the following meaning:
Parameter
ipv4
ucast_addr
fqdn-name
FQDN
ipv6
ip6_addr
port
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
If you do not select any parameters from the parameter list, the default value is used.
Result
The settings for the Syslog server are configured. The Syslog server was entered in the
table.
Further notes
You delete the entry with the
You can display the status of this function and other information with the
command.
12.6.2.2

no syslogserver

Description
With this command, you delete a Syslog server.
Requirement
You are in the EVENTS configuration mode.
The command prompt is as follows:
cli(config-events)#
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
Description
Keyword for an IPv4 address
IPv4 unicast address of the Syslog
server
Keyword for a domain name
Domain name (Fully Qualified Domain
Name)
Keyword for an IPv6 address
IPv6 address of the Syslog server
Port of the Syslog server on which the
messages are received
command.
no syslogserver
Diagnostics
12.6 Syslog Client
Range of values / note
-
Enter a valid IPv4 address.
-
Maximum of 100 characters
-
Enter a valid IPv6 address.
0 ... 65535
Default: 514
show events config
819