Show Ip Interface - Siemens SCALANCE XC-200 Configuration Manual

Configuration
3.1 System
3.1.1.10

show ip interface

show ip interface
Description
This command shows the configuration of one, several or all IP interfaces.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
Thiscli> or cli#
Syntax
Call up the command with the following parameters:
show ip interface
}]
The parameters have the following meaning:
Parameter
Vlan
vlan-id
interface-
type
interface-
id
loopback
For information on identifiers of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
If you do not select any parameter from the parameter list, the configuration is displayed for
all available IP interfaces.
Result
The configuration of the selected IP interface is displayed.
54
[{
Vlan <vlan-id(1-4094)> |
<interface-type> <interface-id> |
loopback
Description
Keyword for a VLAN connection
Number of the addressed VLAN
Type or speed of the interface
Module no. and port no. of the interface
Loopback
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Range of values / note
-
1 ... 4094
Enter a valid interface.
-
Configuration Manual, 07/2017, C79000-G8976-C361-06