No Interface - Siemens SCALANCE XM-400 Configuration Manual

Configuration
3.1 System
Result
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
The placeholder
Type of interface
cpu0
vlan
port-channel
gigabitethernet
extreme-ethernet
The placeholders
The ranges of values for the logical interfaces VLAN and port channel can be found in the
table above. You can only call up interfaces that you created with the
command.
The ranges of values from the physical interfaces depend on the hardware configuration.
Further notes
You exit the Interface configuration mode with the
You delete a logical interface with the
You display the status and the configuration of the interfaces with the
command.
3.1.12.2

no interface

Description
With this command, you delete a logical interface.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
78
is replaced by the following name of the interface:
$$$
Command prompt
cli(config-if-cpu0)#
cli(config-if-vlan-$)#
cli(config-if-po-$)#
cli(config-if-Gi$-$)#
cli(config-if-Ex$-$)#
or denote the numbering of the interface.
$ $-$
no interface
or command.
end exit
command.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
or
vlan channel-group
show interfaces