No Ip Igmp Snooping Port-Purge-Interval; Commands In The Vlan Configuration Mode - Siemens SCALANCE XC-200 Configuration Manual

Layer 2 management protocols
8.2 IGMP snooping
Further notes
You can reset the setting to the default with the no ip igmp snooping port-purge-
interval command.
You can display the status of this function and other information with the show ip igmp
snooping globals command.
8.2.2.7

no ip igmp snooping port-purge-interval

Description
With this command, you reset the setting for the purge time to the default value.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no ip igmp snooping port-purge-interval
Result
The purge time is reset to the default value.
Further notes
You configure the setting with the ip igmp snooping port-purge-interval command.
You can display the status of this function and other information with the show ip igmp
snooping globalscommand.
8.2.3

Commands in the VLAN configuration mode

This section describes commands that you can call up in the VLAN Configuration mode.
In the Global Configuration mode, enter the vlan $$$ command to change to this mode.
When doing this, you need to replace the $$$ placeholders with the relevant VLAN ID.
384
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06