No Ip Address - Siemens SCALANCE XC-200 Configuration Manual

Result
The IP address is assigned.
Note
Effectiveness of the command
The command is effective immediately. If you configure the interface via which you access the
device, the connection will be lost!
Further notes
You delete the setting with the no ip address command.
6.1.7.2

no ip address

Description
With this command, you delete the assignment of an IP address and disable DHCP.
Requirement
You are in the Interface Configuration mode of VLAN.
The command prompt is as follows:
cli(config-if-vlan-$$$)#
Syntax
Call up the command with the following parameters:
no ip address [{ <ucast_addr> | dhcp }]
The parameter has the following meaning:
Parameter
ucast-addr
dhcp
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
Result
If DHCP was enabled on this interface, DHCP is now disabled. Any existing dynamically
learned IP address will be automatically converted to a static IP address.
If static IP addresses were configured and if no explicit IP address was transferred as a
parameter, all static IP addresses will be deleted from this interface.
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Description
Value for an IPv4 unicast address
Specify this parameter if you want to
disable the DHCP function explicitly.
Network structures
6.1 VLAN
Range of values / note
Enter a valid IPv4 unicast address.
-
211