No Link - Siemens SCALANCE XC-200 Configuration Manual

Diagnostics
12.1 Event and fault handling
If you do not select an interface, the function is enabled for all available interfaces.
Result
The settings for monitoring the physical network connections have been configured.
Further notes
You display the setting with the show events faults config command.
You disable the function with the no link command.
12.1.8.11

no link

Description
With this command, you disable the monitoring of the physical network connections for cable
breaks or for pulling of the connector.
Requirement
You are in the EVENTS configuration mode.
The command prompt is as follows:
cli(config-events)#
Syntax
Call up the command with the following parameters:
no {up|down}[{<interface-type><interface-id>}]
The parameters have the following meaning:
Parameter
up
down
interface-
type
interface-
id
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
If you do not select an interface, the function is disabled for all available interfaces.
564
Description
The message when establishing a connection is dis‐
abled
The message when a connection is down is disabled -
Type or speed of the interface
Module no. and port no. of the interface
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Range of values / note
-
Enter a valid interface.
Configuration Manual, 07/2017, C79000-G8976-C361-06