No Interface Range - Siemens SCALANCE XC-200 Configuration Manual

Network structures
6.1 VLAN
Result
The interfaces or interfaces of VLANs were put together to form an interface range.
The command prompt is as follows:
cli(config-if-vlan-range)#
The configuration commands you enter in a mode apply to all interfaces of this area.
Further notes
With the no interface range command, you remove VLANs from this range or break it
up.
6.1.2.3

no interface range

Description
With this command, you remove the interfaces or interfaces of VLANs from the interface range
or break it up if you first remove all previously added interfaces.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no interface range vlan <vlan-id(1-4094)> - <vlan-id(2-4094)>
The parameters have the following meaning:
Parameter
vlan
vlan-id
vlan-id
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
If you address several VLANs, you must insert a blank before and after the hyphen, for
example no interface range vlan 5 - 10.
Result
The VLANs have been removed from the specified interface area.
174
Description
Keyword for a VLAN connection
Number of the addressed VLAN
Number of the addressed VLAN
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Range of values / note
-
1 ... 4094
2 ... 4094
Configuration Manual, 07/2017, C79000-G8976-C361-06