No Spanning-Tree - Siemens SCALANCE XC-200 Configuration Manual

Result
The spanning tree function is enabled.
If you enable Spanning Tree, passive listening is disabled.
Further notes
The default setting of the function with PROFINET variants is "disabled".
The default setting of the function with EtherNet/IP variants is "enabled".
You disable the ring redundancy function with the no ring-redundancy command.
You disable the spanning tree function with the no spanning-tree command.
You can display the status of this function and other information with the show spanning-
tree detailcommand.
You can display information about active ports with the show spanning-tree active
command.
6.3.4.2

no spanning-tree

Description
With this command, you disable the spanning tree function.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no spanning-tree
Result
The spanning tree function is disabled.
Further notes
You enable the spanning tree function with the spanning-tree command.
You can display the status of this function and other information with the show spanning-
tree detailcommand.
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Network structures
6.3 Spanning Tree
229