Clear Spanning-Tree Detected Protocols; Clear Spanning-Tree Counters - Siemens SCALANCE XC-200 Configuration Manual

6.3.2

clear spanning-tree detected protocols

Description
With this command, you restart the protocol transmission process on a specific or on all
interfaces and force renegotiation of the connection settings with the neighboring devices.
Requirement
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
Syntax
Call up the command with the following parameters:
clear spanning-tree detected protocols
The parameters have the following meaning:
Parameter
interface
interface-type
interface-id
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
If you do not select any parameters from the parameter list, the process is restarted for all
interfaces.
Result
The connection settings for spanning tree are renegotiated.
6.3.3

clear spanning-tree counters

Description
With this command, you reset all the statistical counters of the spanning tree function at the
device and port level.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
[{interface<interface-type><interface-id>}]
Description
Keyword for a an interface description
Type or speed of the interface
Module no. and port no. of the interface
Network structures
6.3 Spanning Tree
Range of values / note
-
Enter a valid interface.
227