Link Aggregation; The "Show" Commands; Show Etherchannel - Siemens SCALANCE XC-200 Configuration Manual

6.2

Link aggregation

This section describes commands that configure or manage the bundling of interfaces or
connections between devices.
6.2.1

The "show" commands

This section describes commands with which you display various settings.
6.2.1.1

show etherchannel

Description
This command shows the settings of the Etherchannel.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show etherchannel [[channel-group-number]
The parameters have the following meaning:
Parameter
channel-group-
number
detail
load-balance
port
port-channel
summary
protocol
If you do not select any parameters from the parameter list, the settings of all channels will be
displayed in detail.
Result
The Etherchannel settings are displayed.
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
{detail|load-balance|port|port-channel|summary|protocol}]
Description
Number of the Channel-Group
Detailed display of the settings
Shows which load balancing method is enabled
Information on the Etherchannel port
Information on the Port-Channel
Brief overview of the settings of a Channel-Group
Specification of the protocol set for a Channel-Group
Network structures
6.2 Link aggregation
213