Switchport Priority Default; No Switchport Priority Default - Siemens SCALANCE XM-400 Configuration Manual

Industrial ethernet switches

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

switchport priority default

With this command, you configure the priority default for the interface.

You are in the Interface configuration mode.

The command prompt is as follows:

cli(config-if-$$$)#

Call up the command with the following parameters:

switchport priority default <0-7>

The parameter has the following meaning:

The setting for the default priority of the interface is configured.

Further notes

You reset the priority default to the original default with the

You display this setting and other information with the

With this command, you reset the priority default for the interface to the default value.

The default value is 0.

You are in the Interface configuration mode.

The command prompt is as follows:

cli(config-if-$$$)#

SCALANCE XM-400/XR-500 Command Line Interface (CLI)

Configuration Manual, 11/2015, C79000-G8976-C252-10

Value for the priority default

Network structures

Range of values / note

no switchport priority default

show vlan port config

Show Quick Links

Table of Contents

Scalance xr-500