Network structures
6.1 VLAN
6.1.3.2
no map subnet
Description
With this command, you remove an IPv4 subnet from a VLAN.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
no map subnet <ip-subnet-address>
The parameter has the following meaning:
Parameter
ip-subnet-address
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
Result
The IPv4 subnet was removed.
Further notes
You configure the setting with the
You can display the status of this function and other information with the
mapping
6.1.3.3
switchport acceptable-frame-type
Description
With this command, you configure which types of frames are accepted.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
188
Description
IPv4 subnet address
command.
command.
map subnet
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
Range of values / note
Enter a valid subnet address
show subnet-vlan