Adding An Ntp Server - Siemens RX1500 User Manual

Chapter 5
Setup and Configuration
Figure 298: Network Time Protocol (NTP) Servers Table
If no servers have been configured, add servers as needed. For more information, refer to
"Adding an NTP Server".
Section 5.12.11.2

Adding an NTP Server

To configure an NTP server on the device, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to services » time » ntp » server and click <Add server>. The Key Settings form appears.
Figure 299: Key Settings Form
1. NTP Server Box
3. Configure the following parameter(s) as required:
Parameter
NTP Server
Click Add to create the server configuration. The Network Time Protocol (NTP) Servers form appears.
4.
288
2. Add Button
Description
Synopsis: The host type represents either an IP address or a DNS domain name.
The Internet address of the remote NTP server to be monitored.
RUGGEDCOM ROX II
User Guide
Section 5.12.11.2,
Adding an NTP Server