Fujitsu ETERNUS DX80 S2 Cli User's Manual page 691

Appendix A Error Messages
Message
number
E0093
E0094
E0095
E0097
E0098
E0100
E0101
E0102
E0103
E0110
E0111
E0113
E0114
E0115
Not available under current host affinity mode conditions.
The current host affinity mode does not permit this operation. The Host Affinity Mode can be set or can-
celed by using the "set fc-parameters" command, the "set sas-parameters" command, or the "set iscsi-
parameters" command if necessary.
Not available under current encryption status conditions.
The current encryption mode does not permit this operation. Check the encryption mode by using the
"show encryption" command.
The encryption mode can be set or canceled by using the "set encryption" command if necessary.
Not available under current e-mailing conditions.
The current e-mail send condition does not permit this operation. Confirm whether the e-mail send
condition is enabled by using the "show email-notification" command.
Set the e-mail environment by using the "set email-notification" command if necessary.
Not available under master controller module.
Could not execute this command from the master controller module. Try again from the slave controller
module, which can be accessed by the redundant IP address. For details, refer to the "show network"
command.
Not available under slave controller module.
Could not execute this command from the slave controller module. Try again from the master controller
module.
No space.
There is insufficient space available to allow the specified operation. Check the available space.
No memory.
Could not allocate working memory. Close other sessions and try again.
Not available under system disk status.
This message indicates that the execution condition does not match with the BUD (Bootup and Utility
Device) status. Confirm the BUD status by using the "show disks" command.
Additional host interface port license is required.
Could not perform host interface port expansion because a host interface port license has not been
registered yet. Use the "set host-port-license" command to register the license.
Resource does not exist.
Resources corresponding to the specified parameter do not exist. Check the resources associated with the
object identified in the details of this message
Resource is not reserved.
Resources corresponding to the specified parameter are not reserved. Check the status of resources
associated with the object identified in the details of this message.
No SNMP trap information.
Could not execute because SNMP trap information is not registered. Check the SNMP trap information by
using the "show snmp-trap" command.
Create SNMP trap information by using the "create snmp-trap" command if necessary.
No volumes in the RAID Group / Thin provisioning pool.
There are no volumes in the specified RAID group or Thin Provisioning Pool. Check the number of volumes
in the specified RAID group or Thin Provisioning Pool by using the "show raid-groups" command or the
"show thin-pro-pools" command
Performance monitor has not started.
Collecting performance information has not started. Start collecting performance information by using
the start-performance command.
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
Message
Countermeasure for the error
691
P2X0-1030-09ENZ0