Fujitsu ETERNUS DX80 S2 Cli User's Manual page 460

Chapter 4 Function/System Settings and Display
4.3 Network Management > show network
# Allowed IP1
...
# Allowed IP16
# MAC Address
# FST port Enable
FST port name and [Enable/Disable]
# IPv4
Whether IPv4 settings are enabled or disabled [Enable/Disable]
# Master IP
# Slave IP
# Subnet Mask
# Speed and Duplex Auto Negotiation
# MAC Address
• FST port information is not supported in ETERNUS DX80 S2/DX90 S2.
• For the DX8700 S2, the MAC address of the port on the Service Controller is displayed.
Example: # MAC Address SVC#0 01:02:03:04:05:06 SVC#1 11:12:13:14:15:16
::.0
IP address, prefix length
::,0
IP address, prefix length
List of IP addresses for connection destinations 1 to 16
CM#0 21:22:23:24:25:26 CM#1 31:32:33:34:35:36
Each MAC address of the RMT port on both controller modules
A hyphen (-) is displayed to the field of CM#1 in the case of single-controller type.
Enable
192.168.128.1
IP address of the FST port on master CM
192.168.128.1
IP address of the FST port on slave CM
This is not displayed for a single-controller type.
255.255.255.0
Subnet mask of the FST port
Connection speed of the FST port
CM#0 41:42:43:44:45:46 CM#1 51:52:53:54:55:56
Each MAC address of the FST port on both controller modules
A hyphen (-) is displayed to the field of CM#1 in the case of single-controller type.
460
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0