Fujitsu ETERNUS DX80 S2 Cli User's Manual page 147

Chapter 3 Configuration Settings and Display
3.4 Volume Management > create volume
-virtual-size Optional. This parameter must be specified when selecting an SDV type, and can specify the
-count
-copy-protection
-attention
-encryption Optional. This parameter specifies whether the encryption by a CM is performed. When
-wide-stripe-size
-concatenation-order
volume size. If omitted, the existing setting is not changed. In addition, this parameter cannot
be specified when selecting a type other than SDV.
Optional. This parameter specifies the number of volumes to be created. If omitted, a single
volume is created with the name determined by the "-name" parameter. Requesting two or
more volumes results in the creation of volumes with names determined by the "-name"
parameter with a trailing index number, starting from "0". Only "1" can be specified when "-
concatenation-order manual" is specified.
Example: For "-count 3 -name abc", the volumes named "abc0", "abc1", and "abc2" are created.
If these volumes already exist, the names of the created volumes use incrementing index
numbers.
Optional. This parameter protects a volume from being specified for the copy destination. It is
possible to set it even when there is already a copy session. The copy license is necessary for
this setting. If this parameter is omitted, "disable" is set.
enable Volume is protected at the copy destination.
disable Volume is not protected at the copy destination.
Optional. This parameter specifies the attention level of the Thin provisioning volume (TPV).
This parameter can be specified when the "-type tpv" parameter is specified. The settable
range is 1 – 200%. If this parameter is omitted, attention is not changed.
"enable" is selected, the specified volume data is encrypted. If the option is omitted, "default"
is set.
enable The volume data is encrypted.
disable The volume data is not encrypted.
Optional. This parameter specifies the Wide Stripe Size for the Wide Striping Volume that is to
be created. This parameter can only be specified when the "-type wsv" parameter is set. If
omitted, then it is handled as if "normal" is selected.
normal The Wide Stripe Size for the Wide Striping Volume is set to 16MB.
small The Wide Stripe Size for the Wide Striping Volume is set to 2MB. Note that if
the Stripe Size of the RAID group exceeds 2MB, the actual Stripe Size of the
RAID group is used for the WSV that is to be created.
Optional. This parameter specifies whether to manually set the concatenation order for the
RAID groups of a Wide Stripe Volume that is to be created. This parameter can only be specified
when the "-type wsv" parameter is set.
If omitted, then it is handled as if "auto" is selected.
auto The concatenation order for the RAID groups is automatically set.
manual The RAID groups are concatenated in the order specified by the "rg-number" or
"-rg-name" parameter.
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
147
P2X0-1030-09ENZ0