Fujitsu ETERNUS DX80 S2 Cli User's Manual page 42

Chapter 2 Status Display
2.1 Storage System Status > show fru-ce
Memory Size
Parts Number
Serial Number
Hardware Revision
CPU#n Clock
CM Active EC
CM Next EC
BIOS Active EC
BIOS Next EC
CM EXP Active EC
CM EXP Next EC
CM#n Internal Parts Status and Status Code (n: The controller module number)
Memory#
Memory# Parts Number
Memory# Serial Number
Memory# Hard Revision
BUD#
Memory size of a controller module.
Parts number
Serial number
Hardware version
CPU clock frequency
An EC number of the active firmware (The current operating firmware)
An EC number of the stand-by firmware (The generation number of the firmware after the next
power cycle)
An EC number of the active firmware (The current operating firmware)
An EC number of the stand-by firmware (The generation number of the firmware after the next
power cycle)
An EC number of the active firmware (The current operating firmware) (only for the ETERNUS
DX80 S2/DX90 S2, ETERNUS DX410 S2/DX440 S2, and ETERNUS DX8100 S2)
An EC number of the stand-by firmware (The generation number of the firmware after the next
power cycle) (only for the ETERNUS DX80 S2/DX90 S2, ETERNUS DX410 S2/DX440 S2, and
ETERNUS DX8100 S2)
Memory status and the status code
Memory parts number
Memory serial number
Memory hard revision
BUD (Bootup and Utility Device) status and the status code
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
42
P2X0-1030-09ENZ0