Set Lun-Group - Fujitsu ETERNUS DX80 S2 Cli User's Manual

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set lun-group

set lun-group

This command changes an existing LUN group and can also be used to add a definition to the LUN group.
■
Syntax
set lun-group {-lg-number
[{-volume-number
■ Parameter
-lg-number
or
-lg-name
-name
-volume-number
or
-volume-name
-lun
source_lg_number
volume_numbers
| -volume-name
This parameter specifies the LUN group identifier to be changed. Only one LUN group can be
specified at the same time. For details, refer to
Optional. This parameter specifies the new LUN group name. Only one name can be specified
at the same time. If omitted, the existing setting is not changed.
Optional. This parameter specifies the volume identifiers to add a definition to the specified
LUN group, and is paired with the "-lun" parameter. One or more parameters can be specified
at the same time. If omitted, the existing setting is not changed. For details, refer to
Volume Syntax" (page 22). If two or more LUNs are specified, these parameters must also be
specified in the same order as the associated volumes. Any already assigned definitions
cannot be specified.
Example:
-volume-number 10-12 -lun 1-3
-> The volume #10 and LUN 1 are pairs.
-> The volume #11 and LUN 2 are pairs.
-> The volume #12 and LUN 3 are pairs.
-volume-name v1,v2 -lun 1-2
-> The volume named "v1" and LUN 1 are pairs.
-> The volume named "v2" and LUN 2 are pairs.
Optional. This parameter specifies LUNs to add a definition to the specified LUN group, and is
paired with volume identifiers. If omitted, the existing setting is not changed. If two or more
volume identifiers are specified, these parameters must be specified in the same order as the
associated LUNs. Any already assigned definitions cannot be specified.
Two or more parameters can be specified by separating them with a comma, a hyphen, or
both.
Example: -lun 0,1 -lun 0-10 -lun 1,6-8
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
source_lg_name
| -lg-name
volume_names
} {-lun
"1.2.11 Affinity Group Syntax" (page
263
name
} [-name ]
luns
}]
24).
"1.2.9
P2X0-1030-09ENZ0