Discover Host-Iscsi-Names - Fujitsu ETERNUS DX80 S2 Cli User's Manual

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > discover host-iscsi-names

discover host-iscsi-names

This command displays a list of the iSCSI host names that have been discovered for the specified iSCSI port(s).
The iSCSI parameters must be set up first using the "set-iscsi-parameters" command.
• An iSNS server definition must be set to use this command.
• Host Affinity Mode must be enabled to use this command.
• Even if an iSNS server is defined, expected IP addresses may not be displayed.
- If multiple hosts run one of the following host OSes, have an identical iSCSI name, and have different
IP addresses, the IP address of only one of the hosts can be displayed.
•Windows Server 2008 R2
•Windows Server 2008
•Windows Server 2003
•Solaris 10
• Host information cannot be displayed if the host is running Solaris 11.
■ Syntax
discover host-iscsi-names [-port {
■ Parameter
-port
■ Output
# CM#0 CA#0 Port#0
A
# Alias
# IQN-DXL1
B
A: The target host interface port
B: The alias of the iSCSI host discovered
C: The discovered iSCSI name
D: The IP address of the discovered iSCSI host
xyz
|all}]
Optional. This parameter specifies the iSCSI interface port(s) whose discovered host iSCSI
names are to be listed. One or more host interface ports can be specified at the same time. If
this parameter is omitted, the hosts that are discovered for all the iSCSI interface ports are
displayed.
Example: -port 000,100
For details, refer to "1.2.14 Host Interface Port Syntax" (page
xyz "x" is the controller module (CM) number, "y" is the CA number, and "z" is the iSCSI port
number.
Example: "123" indicates CM#1-CA#2-iSCSI Port#3
all All the iSCSI interface ports (default)
iSCSI Name
iqn.1991-05.com.microsoft
C
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
249
25).
IP Address
2001::123:1234:2309:0001
D
P2X0-1030-09ENZ0