Show Mapping - Fujitsu ETERNUS DX80 S2 Cli User's Manual

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > show mapping

show mapping

This command displays a list of the mapping definitions of the volumes with host LUNs. Individual volumes or
host interface ports can be specified. This command cannot be used when Host Affinity Mode for the host
interface port is enabled.
■ Syntax
show mapping [-port {
■ Parameter
-port
-volume-number
or
-volume-name
■ Output
# CM#0 CA#0 Port#0 (Host Affinity Mode Disable)
A
# LUN Volume
# No. Name
# 100 1001 VOLUME_000000001 Available
C D E
A: Host interface port
B: Host affinity mode
C: Logical unit number (LUN)
D: Volume number
E: Volume name
F: Volume status
G: Volume size
xyz |all}] [-volume-number
Optional. This parameter specifies the host interface ports. Two or more parameters can be
specified by separating them with a comma. If omitted, all the host interface ports are
displayed.
Example: -port 000,100
For details, refer to "1.2.14 Host Interface Port Syntax" (page
xyz "x" is the controller module (CM) number, "y" is the CA number, and "z" is the host port
number.
Example: "123" indicates CM#1-CA#2-Host port#3
all All the host interface ports (default)
Optional. This parameter specifies the volume identifiers. One or more parameters can be
specified. For details, refer to
identifiers are displayed.
B
Status
F
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
volume_numbers | -volume-name
"1.2.9 Volume Syntax" (page
Size(MB)
32
G
289
volume_names
25).
22). If omitted, all the volume
P2X0-1030-09ENZ0
]