Fujitsu ETERNUS DX80 S2 Cli User's Manual page 155

Chapter 3 Configuration Settings and Display
3.4 Volume Management > show volumes
-mode
■ Output
#Volume Status
#No. Name
# 1 VOL001 Available SDV CM
#A B C
A: Volume number
B: Volume name
C: Volume status
D: Volume type
E: Encryption status
F: The number that configures volume if expanded
G: RAID group, Thin Provisioning Pool or Flexible Tier Pool number
H: RAID group, Thin Provisioning Pool or Flexible Tier Pool name
I: Volume size. For SDVs, Virtual-size is displayed.
J: Reserved deletion sign for SDPV only
K: Copy protection
L: Used Status for TPV or FTV
M: Measurements for TPV or FTV
N: Attention level for TPV or FTV
O: Balancing level for TPV only
P: FTRP number to which the FTV is preferentially allocated
Q: Used Capacity for TPV or FTV
Optional. This parameter toggles the extended output mode. If the mode is omitted, "default"
is set.
• Only one parameter can be specified.
• When the "-mode expansion", "-mode uid" or "-mode wsv" parameter is specified, other
parameters cannot be specified at the same time.
expansion Detailed information of the configuration of an expanded volume (LUN
concatenation volume) can be displayed.
uid NAA identifiers (UIDs) are displayed.
wsv The information for the concatenated RAID groups of the WSV are displayed.
ftv The usage status of the FTSPs for the FTV is displayed.
The FTSPs are listed in the following order according to disk type; SSDs, SEDs,
Nearline disks, and then Online disks. This option can be specified together with
the "-ftsp-number" parameter or the "-ftsp-name" parameter. "Used Capacity"
indicates the total used capacity for the FTSPs. "Volume Used Capacity" indicates
the used capacity for the FTSPs of an FTV. "Usage Rate" indicates (Volume Used
Capacity)/(total capacity of all the FTVs)  100. The result for this formula is
rounded down to the nearest whole number. This may result in the sum of the
displayed "Usage Rate" values not being 100% even when the actual value is
100%. When no FTSPs are used, the "Usage Rate" is 0%.
default The same result as when this parameter is omitted.
Type Encryption Expansion RG or TPP
(Concatenation) No. Name
10 10 RGP010
D E F G H
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
Size(MB) Reserved Copy Used Measurements Attention Balancing Priority Used
Deletion Protection Status
32768 NO disable Normal
I J K L M
155
(%) Level Capacity(MB)
32 70 High 0
N O P Q
P2X0-1030-09ENZ0
0