Fujitsu ETERNUS DX80 S2 Cli User's Manual page 456

Chapter 4 Function/System Settings and Display
4.3 Network Management > set network
-speed
-primary-dns-ip
-secondary-dns-ip
-wake-on-lan
Optional. This parameter specifies the connection speed of the specified Ethernet port. If
omitted, the existing setting is not changed.
1000 1Gbit/s
100full 100Mbit/s full-duplex
100half 100Mbit/s half-duplex
10full 10Mbit/s full-duplex
10half 10Mbit/s half-duplex
auto Auto negotiation
Optional. This parameter specifies the primary DNS IP address for the Ethernet port. The format
is IPv4 standard notation (a base 256 "d.d.d.d" string) or IPv6 format. The types of IPv6
addresses that can be specified are global unicast addresses (including 6to4 addresses) and
unique local unicast addresses. This parameter cannot be specified when "-port fst" is
specified. If omitted, the existing setting is not changed.
When "v4" is specified for the "-ip-format" parameter, the IP addresses must be specified using
IPv4 standard notation. When "v6" is specified for the "-ip-format" parameter, the IP addresses
must be specified in IPv6 address format. This parameter cannot be specified when "-port fst" is
specified.
Optional. This parameter specifies the secondary DNS IP address for the Ethernet port. The
format is IPv4 standard notation (a base 256 "d.d.d.d" string) or IPv6 format. The types of IPv6
addresses that can be specified are global unicast addresses (including 6to4 addresses) and
unique local unicast addresses. This parameter cannot be specified when "-port fst" is speci-
fied. If omitted, the existing setting is not changed. When "v4" is specified for the "-ip-format"
parameter, the IP addresses must be specified using IPv4 standard notation. When "v6" is
specified for the "-ip-format" parameter, the IP addresses must be specified in IPv6 address
format. This parameter cannot be specified when "-port fst" is specified.
Optional. This parameter specifies whether or not the Wake on LAN (WOL) function is enabled.
This function can be independently set for each Ethernet port (MNT/RMT). The initial value is
disabled. This parameter cannot be specified when "-port fst" selected. If omitted, the existing
setting is not changed. This parameter cannot be specified when "-port fst" is specified.
enable Wake on LAN is enabled.
disable Wake on LAN is disabled.
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
456
P2X0-1030-09ENZ0