Show Host-Response - Fujitsu ETERNUS DX80 S2 Cli User's Manual

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > show host-response

show host-response

This command displays the host response settings. If the host response name or number is omitted, a
summary of all host responses is displayed. If the host response name or number is included as a parameter,
then the details of the specified host response parameters are displayed.
■ Syntax
show host-response
[-host-response-number
■
Parameter
-host-response-number
or
-host-response-name
■ Output
The following details are displayed when a host response identifier is specified.
# Host Response No.5
# Host Response Name
# Byte-0 of Inquiry Response
# Inquiry VPD ID Type
# Inquiry Standard Data Version
# Command Timeout Interval
# Load Balance Response
# Reservation Conflict Response for Test Unit Ready
# Change Volume Mapping
# Volume Capacity Expansion
# Vendor Unique Sense Code
# Host Specific Mode
# Asymmetric / Symmetric Logical Unit Access
# iSCSI Discovery Reply Mode
# TPGS Mode
# TPG Referrals
# iSCSI Reservation Range
When no parameters are specified, a summary list is displayed.
# Host Response
# No. Name
1 am0001
A B
A: Host response number
B: Host response name
host_response_numbers
Optional. This parameter specifies the host response identifier and detailed information of the
host response is displayed. One or more parameters can be specified. If omitted, a summary
list is displayed. For details, refer to
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
| -host-response-name
"1.2.12 Host Response Syntax" (page
am0005
Not conversion (Default)
Type1 + Type3 (Default)
Version 5 (Default)
25 (Default)
Unit Attention (Default)
Normal (Default)
Not report (Default)
Not report (Default)
Not report (Default)
Normal (Default)
ACTIVE-ACTIVE / PREFERRED_PATH
Reply all port (Default)
Enable (Default)
Disable (Default)
Port (Default)
297
host_response_names
]
24).
P2X0-1030-09ENZ0