Fujitsu ETERNUS DX80 S2 Cli User's Manual page 336

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set host-lu-qos
-schedule-number
■ Example(s)
The following example sets the Port QoS and the default QoS schedule for the Port QoS:
CLI> set host-lu-qos -mode port-qos -port 000 -bandwidth-limit 15
The following example sets the Host QoS and the default QoS schedule for the Host QoS:
CLI> set host-lu-qos -mode host-qos -host-type iscsi -host-number 12 -bandwidth-limit 0
The following example sets the LU QoS and the default QoS schedule for the LU QoS (for a port with the Host
Affinity mode enabled):
CLI> set host-lu-qos -mode lu-qos -port 000 -host-number 12 -lu-qos-group 1
The following example sets the LU QoS and the default QoS schedule for the LU QoS (for a port with the Host
Affinity mode disabled):
CLI> set host-lu-qos -mode lu-qos -port 000 -lu-qos-group 1
The following example restores the initial setting of the LU QoS and sets the default QoS schedule for the LU
QoS (for a port with the Host Affinity mode enabled):
CLI> set host-lu-qos -mode lu-qos -port 000 -host-number 12 -lu-qos-group ""
The following example restores the initial setting of the LU QoS and sets the default QoS schedule for the LU
QoS for all of the host affinities of the specified port:
CLI> set host-lu-qos -mode lu-qos -port 000 -lu-qos-group ""
The following example sets the QoS schedule for the Port QoS:
CLI> set host-lu-qos -mode port-qos -port 000 -bandwidth-limit 15 -event-number 2 -schedule-number 0
The following example sets the QoS schedule for the Host QoS:
CLI> set host-lu-qos -mode host-qos -host-type iscsi -host-number 12 -bandwidth-limit 0 -event-number 7 -schedule-number 1
The following example sets the QoS schedule for the LU QoS (for a port with the Host Affinity mode enabled):
CLI> set host-lu-qos -mode lu-qos -port 000 -host-number 12 -lu-qos-group 1 -event-number 2 -schedule-number 4
Optional. This parameter specifies the QoS schedule number. Multiple QoS schedule numbers
can be specified. When multiple values are specified, the number of values that are specified
for this parameter must be the same as the "-port" parameter or the "-host-number"
parameter. Specify two double quotation marks ("") to release the assigned QoS schedule.
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
336
P2X0-1030-09ENZ0