Create Raid-Group - Fujitsu ETERNUS DX80 S2 Cli User's Manual

Chapter 3 Configuration Settings and Display
3.3 RAID Group Management > create raid-group

create raid-group

This command creates a RAID group with the specified RAID group name, RAID level and disks. When
registering a hot spare, refer to the "set global-spare" or the "set dedicated-spare" command.
■ Syntax
create raid-group -name
[-assigned-cm {0|1|cm0cpu0|cm0cpu1|cm1cpu0|cm1cpu1|cm2cpu0|cm2cpu1|
cm3cpu0|cm3cpu1|cm4cpu0|cm4cpu1|cm5cpu0|cm5cpu1|cm6cpu0|cm6cpu1|
cm7cpu0|cm7cpu1|auto}] [-stripe-depth { 64kb | 128kb | 256kb | 512kb | 1024kb }]
■
Parameter
-name
-disks
-level
-assigned-cm
alias_name
-disks
This parameter specifies the alias name of a RAID group. Only one name can be specified. For
details, refer to "1.2.4 Alias Name Syntax" (page
This parameter specifies which disks will form the RAID group. For details, refer to
Syntax" (page 19).
This parameter specifies the RAID level.
0 RAID0
1 RAID1
5 RAID5
6 RAID6
10 RAID1+0
50 RAID5+0
Optional. This parameter specifies the assigned controller (CM number) of the specified RAID
group. If "auto" is specified, the fixed controller, which is calculated automatically by the
system, is assigned. If this parameter is omitted, the "auto" mode is set.
For the ETERNUS DX80 S2/DX90 S2:
0 Controller module#0
1 Controller module#1
auto Automatically (default)
For the ETERNUS DX410 S2/DX440 S2 and ETERNUS DX8100 S2:
cm0cpu0 Controller module#0 CPU#0
cm0cpu1 Controller module#0 CPU#1
cm1cpu0 Controller module#1 CPU#0
cm1cpu1 Controller module#1 CPU#1
auto Automatically (default)
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
disks
-level {0|1|5|6|10|50}
20).
112
"1.2.3 Disk
P2X0-1030-09ENZ0