Fujitsu ETERNUS DX80 S2 Cli User's Manual page 166

Chapter 3 Configuration Settings and Display
3.4 Volume Management > start migration
-encryption
-zero-reclamation
-wide-stripe-size
-concatenation-order
■ Example(s)
The following example moves the volume named "VOL003" to the RAID group named "RGP004". The new
volume size is 512GB:
CLI> start migration -volume-name VOL003 -rg-name RGP004 -size 512gb
Optional. This parameter specifies whether the encryption by a CM is performed. When
"enable" is selected, the specified volume data is encrypted. If omitted, then it is handled as if
"disable" is selected.
enable The volume data is encrypted
disable The volume data is not encrypted.
This parameter specifies whether Zero Reclamation is performed after migration is complete. If
omitted, then it is handled as if "disable" is selected. This parameter cannot be set when the
migration destination is a RAID group. "enable" cannot be specified while Zero Reclamation is
being performed for a migration source volume.
enable Zero Reclamation is started after migration is complete.
disable Zero Reclamation is not started after migration is complete.
Optional. This parameter specifies the Wide Stripe Size of a migration source Wide Striping
Volume. This parameter can only be specified when the migration source is a Wide Striping
Volume. If omitted, then it is handled as if "normal" is selected.
normal The Wide Stripe Size for the Wide Striping Volume is set to 16MB.
small The Wide Stripe Size for the Wide Striping Volume is set to 2MB. Note that if
the Stripe Size of the RAID group exceeds 2MB, the actual Stripe Size of the
RAID group is used for the WSV that is to be created.
Optional. This parameter specifies whether to manually set the concatenation order for the
RAID groups of a migration source Wide Stripe Volume. This parameter can only be set when
the migration source is a Wide Striping Volume. If omitted, then it is handled as if "auto" is
selected.
auto The concatenation order for the RAID groups is automatically set.
manual The RAID groups are concatenated in the order specified by the "rg-number" or
"-rg-name" parameter.
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
166
P2X0-1030-09ENZ0