Start Host-Lu-Qos-Performance - Fujitsu ETERNUS DX80 S2 Cli User's Manual

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > start host-lu-qos-performance

start host-lu-qos-performance

This command starts the collection of Host-LU QoS performance information.
■
Syntax
start host-lu-qos-performance [-port {
■ Parameter
-port
■
Example(s)
The following example starts the collection of Host-LU QoS performance information:
CLI> start host-lu-qos-performance
The following example starts the collection of Host-LU Qos performance information from the specified
ports:
CLI> start host-lu-qos-performance -port 000,101
xyz
Optional. This parameter specifies the ports from which the Host-LU QoS performance
information is collected. Two or more ports can be specified by separating them with a comma.
Example: -port 000, 100
For more details, refer to "1.2.14 Host Interface Port Syntax" (page
xyz "x" is the controller module (CM) number, "y" is the CA number, and "z" is the port
number.
Example: "123" indicates CM#1-CA#2-Port#3
all All the ports
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
|all}]
347
25).
P2X0-1030-09ENZ0