Set Network - Fujitsu ETERNUS DX80 S2 Cli User's Manual

Chapter 4 Function/System Settings and Display
4.3 Network Management > set network

set network

This command sets up parameters for the Ethernet network, and checks the consistency of parameters. If the
system detects an inconsistency between the parameters, the command is terminated abnormally.
• An IP address can be deleted by specifying it as "0.0.0.0".
• An IP address that is used for connection to the MNT port on the master controller module (CM) cannot be
deleted.
• When critical changes are made (such as changing a subnet address), all of the network parameters
should be reconfigured.
• When a network change means that the connection cannot be maintained, the user is logged off
automatically.
• When "fst" is specified for "-port", gateway, DNSs and IP addresses cannot be set.
■ Syntax
set network -port {maintenance | remote | fst} [-ip-format {v4|v6}] [-ipv6-set-auto {disable|enable}]
[-master-ip
[-slave -link-local-ip
netmask
[-netmask
[-allow-ip1
[-allow-ip4
[-allow-ip7
[-allow-ip10
[-allow-ip13
[-allow-ip16
[-primary-dns-ip
■ Parameter
-port
-ip-format
ip_address ] [-slave-ip ip_address
ip_address
] [-master-connect-ip
] [-subnet-prefix-length
ip_address netmask
, ] [-allow-ip2
ip_address netmask
, ] [-allow-ip5
ip_address netmask
, ] [-allow-ip8
ip_address , netmask ] [-allow-ip11
ip_address netmask
, ] [-allow-ip14
ip_address netmask
, ] [-speed {1000|100full|100half|10full|10half|auto}]
ip_address
] [-secondary-dns-ip
This parameter specifies the Ethernet port.
maintenance
maintenance port (MNT port)
remote remote port (RMT port)
fst FST port (only for the ETERNUS DX410 S2/DX440 S2 and ETERNUS DX8100 S2/
DX8700 S2)
"fst" is not supported in the ETERNUS DX80 S2/DX90 S2.
Optional. This parameter specifies the format of the IP address that is to be set. If omitted, IPv4
is selected. This parameter can be specified when "maintenance" or "remote" is specified for
the "-port" parameter.
v4 The IPv4 setting is performed.
v6 The IPv6 setting is performed.
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
] [-master-link-local-ip ip_address
ip_address
] [-slave-connect-ip
length gateway
] [-gateway
ip_address netmask
, ] [-allow-ip3
ip_address netmask
, ] [-allow-ip6
ip_address netmask
, ] [-allow-ip9
ip_address , netmask ] [-allow-ip12
ip_address netmask
, ] [-allow-ip15
ip_address
] [-wake-on-lan {enable|disable}]
452
]
ip_address
]
]
ip_address netmask
, ]
ip_address netmask
, ]
ip_address netmask
, ]
ip_address , netmask
ip_address netmask
,
P2X0-1030-09ENZ0
]
]