Chapter 4 Function/System Settings and Display
4.3 Network Management > set firewall
■
Parameter
-port
-http
-https
-telnet
-ssh
-maintenance-secure
-icmp
This parameter specifies the Ethernet port.
maintenance
MNT port
remote
RMT port
fst
FST port
"fst" is not supported in the ETERNUS DX80 S2/DX90 S2.
Optional. This parameter specifies if the "http" application port is opened or closed. If omitted,
the existing setting is not changed. The initial state is "open".
open
Application port "http" is opened.
close
Application port "http" is closed.
Optional. This parameter specifies if the "https" application port is opened or closed. If omitted,
the existing setting is not changed. The initial state is "open".
open
Application port "https" is opened.
close
Application port "https" is closed.
Optional. This parameter specifies if the "telnet" application port is opened or closed. If
omitted, the existing setting is not changed. The initial state is "open".
open
Application port "telnet" is opened.
close
Application port "telnet" is closed.
Optional. This parameter specifies if the "SSH" (Secure Shell) application port is opened or
closed. If omitted, the existing setting is not changed. The initial state is "open".
open
Application port "SSH" is opened.
close
Application port "SSH" is closed.
Optional. This parameter specifies if the "ETERNUS Maintenance Secure (PCCT Secure)"
application port, which is used to connect to the monitoring software, is opened or closed. If
omitted, the existing setting is not changed. The initial state is "open".
open
Application port "ETERNUS Maintenance Secure" is opened.
close
Application port "ETERNUS Maintenance Secure" is closed.
Optional. This parameter specifies if the "ICMP"" (Internet Control Message Protocol)
application port is opened or closed. If omitted, the existing setting is not changed. The initial
state is "open".
open
Application port "ICMP" is opened.
close
Application port "ICMP" is closed.
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
464
P2X0-1030-09ENZ0